OK - heres what the generic site said about SR227 -
"I just disabled local control on two SR227's today (16 July 2006) and verified that this procedure works:
To disable local control on the SR227-C Supersocket, remove the 2 screws from the back of the
socket that enables one to remove the back cover, sliding the black and white wires through the
holes as the back cover is removed. The jumper for pin 7 of the 78570 IC is the small jumper
closest to the RF can transformer and pin 1 of the IC on the component side of the PC board.
Cut it and local control is disabled. The only other jumper on the component side of this PC
board is close to pins 16 and 17 on the other side of the IC close to where a smaller gauge
black wire comes out of the PC board in an area with lots of real estate. Do not cut this one.
Replace the back cover and the 2 screws holding it on and you're done!
Then in another spot:
For the SR227 with CFLs you need to clip the lead of the 1N4004 Diode (The one connected to the 2.2K res and .01 cap on the AM486 schematic) to eliminate the flicker. This can be found near the corner of the circuit board where the black "line" wire is located. If the black wire is on your upper left, the .01 cap is just below it (blue on my SR227). Just to the right of the cap you will see the 1N4004. Just clip the lead at the top and U R done"!"
And then finally in yet another post:
Just in case some are still searching for that (or need a validation it's working)... I modded two of my sr227 used to control CFLs in my inhouse hydroponic garden and it works perfectly now. There's TWO IN4004 DIode on the sr227 board, locate the one just near the big blue capacitor (black wire side of the board) and snip snip, same as the AM486."
There were no photos, and I have no SR227's - one of these is probably correct - they don't all sound the same. Which one(s) do you guys think are correct for my application if I go this way?